PARTS LIST
Remove all contents from packaging. Compare products with the example. If you
are missing any parts please contact your supplier immediately. The carton should
contain:
VECTOR ANTENNA WITH WIRE
BASEPLATE
CAP NUTS AND WASHERS
POWER SUPPLY WITH 10’ OF
CORD
5’ RUBBER MOLDING &
DOUBLE SIDED TAPE
abcoffice
1
1-800-658-8788
ASSEMBLY INSTRUCTIONS
1. Locate the baseplate, cap nuts
and washers.
2. Place the antenna on top of
the baseplate, aligning the
holes in the antenna base with
the studs on the baseplate.
Make sure that the power
supply wire is in the channels
of the antenna base and is not
crushed between the antenna
base and the baseplate.
3. Attach the washers and cap
nuts to the bolts on the
baseplate. DO NOT TIGHTEN.
4. Again make sure that the
power wire is not crushed
between the antenna base and
baseplate and tighten the cap
nuts with a ½” wrench.
5. Connect the wire on the power
supply to the power wire
connected to the antenna. The
wires will only connect in one
direction.
abcoffice
2
1-800-658-8788
POSITIONING THE SYSTEM
6. Position the system a
minimum of 18” (Inches) from
the doorframe and on the side
closest to the door handle.
7. Cut the rubber molding to the
length that will allow it to cover
the wire from the wall to the
system. You must cover the
wire, using a metal pancake
molding If the wire is in an
area where it will be walked
upon.
8. Insert the system power wire
into the rubber pancake
molding through the slit on the
back. Using double sided tape
fasten the rubber molding to
the floor.
9. Plug the power supply into the
closest outlet. We do not
recommend using an
extension cord for the system.
10.Test the system by placing
one of the hard tags into the
system. The system will beep
approximately 1-1/2 seconds
then reset. If a hard tag is held
in the system it will continue to
alarm.
18 Inches
Minimum
abcoffice
3
1-800-658-8788
TAGGING GUIDELINES
1. The tag should be visible to
the customer.
2. Tag uniformly, it speeds up
removal.
3. Tag near a price label. It
assists in the removal.
4. Place the tag as high as
possible when tagging silks &
light or stretchy fabrics.
5. Except for leather goods we do
not recommend locating the
tag at the seams. The seams
are easily cut open to remove
the pin.
6. Avoid placing tags on
waistbands, cuffs, hems or
perimeters. They can be easily
cut off.
Shirts/Blouses/Jackets
7. Insert pins through the
garment then gently push into
the tag.
8. Never force the pin into the
tag.
9. Never use bent pins.
Skirts
abcoffice
4
1-800-658-8788
|